5. DIY Screw Connector Kit Assembly Instruction
The kit can be installed and link up with power supply to light up the Flexlite after you have measured the exact length in your project, this can help you easily do it by yourself below the detailed assembly instruction 。 With the capability of IP67, the Flexlite also can be used both outdoor and indoor.
Screw [x4]
Front connector [x1]
Anti-skidding clip
Rubber gasket
Aluminum mounting piece
[x1]
[x1]
finished assembly view
[x1]
Step 1 Place the anti-skidding clip on the very end of the tubing with the 2 tiny tabs that are pointing inwards still touching the end of the material and crimp in place. Step 2 Line up the alumimum mounting piece so the screw hole face the plug and slide on over the anti-skidding clip. Step 3 Insert the rubber gasket along with slit into the pin of the front connector, put 100% clear silicone on the surface of the rubber gasket. Step 4 Carefully insert thhe pins of the front connector into the gap created behind the FPCB. Step 5 Srew the front connector to the aluminum mounting piece
Step 1
Step 2
Step 5
Step 3
Step 4
DIY Screw Front connector kit Assembly instruction
Anti-skidding clip
Rubber gasket
Screw [x4]
Blank end [x1]
Aluminum mounting piece
finished assembly view
[x1]
[x1]
[x1]
Step 1 Place the anti-skidding clip on the very end of the tubing with the 2 tiny tabs that are pointing inwards still touching the end of the material and crimp in place. Step 2 Line up the alumimum mounting piece so the screw hole face the plug and slide on over the anti-skidding clip. Step 3 Apply 100% clear silicone onto the end face of led Flexlite Step 4 Place the rubber gasket squarely onto the end face of led Flexlite . Step 5 Srew the blank end to the aluminum mounti-- ng piece.
Step 1
Step 2
Step 5 DIY Screw End Cap kit Assembly instruction
Step 4
Step 3
Powered by FlippingBook