6. DIY Snap Connector Kit Assembly Instruction The snap kit can be easily installed than screw kit without any tool, it also has the same waterproof fuction of IP67. Linked up with 24v power supply to light up the Flexlite after you have measured the exact length in your project, this can help you easily do it by yourself below the detailed assembly instruction 。
Polycarbonate outer sleeve [x1]
Rubber gasket
Anti-skidding clip
Front feed connector [x1]
finished assembly view
Joiner bracket
[x1]
Step 1 Let Flexlite goes through polycarbonate outer sleeve, printed instruction aligns with the ‘Snap End’ arrow points in the direction of the feed connector. Step 2 Place the anti-skidding clip on the very end of the neon with the 2 tiny tabs that are pointing inwards still touchi= ng the end of material and crimp in place. Step 3 Place the tip of the assistant tool against the outer side of the internal circuit board within the Flexlite . Carefully push the tool into the Flexlite (max. depth of 12.5mm) and creates a small cavity in the flexible material on the outer side of the circuit board. Step 4 Insert rubber gasket into the pins and apply 100% clear silicone on the surface of it. Align the front feed connector with the cut end part and carefully push its pins into the gaps. Step 5 Gently yet firmly push the joiner bracket onto the front connector assembly. The two parts close together and eventually lock them into place. Step 6 Slide the polycarbonate outer sleeve and butts up to the flange of the front connector.
[x1]
[x1]
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Polycarbonate outer sleeve [x1]
Rubber gasket
Anti-skidding clip
End Cap [x1]
finished assembly view
Joiner bracket
[x1]
[x1]
[x1]
Step 1 Let Flexlite goes through polycarbonate outer sleeve, printed instruction aligns with the ‘Snap End’ arrow points in the direction of the feed connector. Step 2 Place the anti-skidding clip on the very end of the neon with the 2 tiny tabs that are pointing inwards still touching the end of material and crimp in place. Step 3 Place the tip of the assistant tool against the outer side of the internal circuit board within the Flexlite . Carefully push the tool into the Flexlite (max. depth of 12.5mm) so that it creates a small cavity in the flexible material on the outer side of the circuit board. Step 4 Insert rubber gasket into the pins and apply 100% clear silicone on the surface of it. Align end cap with the cut end part and carefully push its pins into the gaps. Step 5 Gently yet firmly push the joiner bracket onto the end cap assembly. The two parts close together and eventually lock them into place. -Step 6 Slide the polycarbonate outer sleeve and butts up to the flange of the front connector.
Step 2
Step 3
Step 1
Step 5
Step 6
Step 4
Powered by FlippingBook